TPU Glossy Full Front Car Paint Protection Film (PPF) for Tesla Model 3 | Tesery
Model 3 · Clear, high-gloss TPU
Vehicle-specific pre-cut TPU film helps defend the most exposed front surfaces of your Model 3 while preserving the look of the original paint.
Explore coverage ↓
Coverage
The kit covers the high-impact panels at the front of the vehicle. Every pattern is cut for the selected Model 3 body style.
The pre-cut piece count and pattern geometry vary by Model 3 version to match differences in the front bumper and body panels.
Performance
Helps reduce UV exposure and preserve the clean, transparent appearance of the film over time.
Approximately 0.22 mm of flexible film between road wear and the vehicle’s painted surface.
Minor surface marks can recover when the topcoat is warmed by sunlight or controlled heat.
Vehicle-specific patterns reduce trimming on the car. High-stretch TPU helps the film conform around complex front-end curves during installation.
Fitment
Panel and bumper geometry varies by generation and trim. Match the vehicle name and model year before installation.
Not sure which version you have? Contact us with your model year, sales region, and clear front and side photos before installation.
Explore the Model 3 Full Car PPF kit for protection beyond the high-impact front panels.
Before & After
BEFORE AFTER
Installation
The pattern removes most on-vehicle cutting, but proper preparation, slip solution and squeegee technique are still essential.
Wash the panel thoroughly, then use a clay bar to remove bonded contaminants.
Apply a suitable slip solution to the panel and the adhesive side of the PPF.
Place the pre-cut film onto the wet panel without stretching it into position too early.
Align the pattern carefully and tack the key corners and reference points in place.
Push slip solution and air outward with overlapping strokes, then secure the edges.
Keep the vehicle dry and allow the film to settle for at least 8–12 hours.
The front bumper includes complex curves and stretch zones. Previous wet-installation experience is strongly advised for the best alignment and finish.
In the Kit
Installation tools are included and shown in the kit image.
PPF Basics
PPF is a physical protective film bonded directly to your paint surface. It absorbs the real-world punishment your car faces every day — highway rock chips, careless parking lot door dings, and fine swirl marks from regular washing. When impact strikes, the film takes the hit, not your factory paint underneath. Your car stays in better condition for longer, and holds its value when it’s time to sell.
PPF helps protect the painted surface from common cosmetic damage. It cannot prevent dents, severe impacts or every form of paint damage.
Support
It covers the full hood, front bumper, left front fender, right front fender and both side mirror caps. Headlights and A-pillar sections are not included unless they are specifically listed in the selected package.
Yes. Each kit uses a vehicle-specific pattern for the selected Model 3 body style, reducing the need to cut directly on the vehicle.
Experienced DIY installers may complete the kit using wet-installation techniques, but professional installation is recommended—especially for the front bumper and other complex curves.
Warmth from sunlight or controlled heat can help the topcoat recover from minor surface marks. Deep cuts, punctures and damage through the film will not self-heal.
Match the body style and model year shown in the fitment guide. If you are unsure, contact customer support with the vehicle year, sales region and clear front and side photos before installing the film.